Need help?Do you have a question about the Ross Opengear TES-8943 and is the answer not in the manual?
General| Model | TES-8943 |
|---|---|
| Category | Computer Hardware |
| Manufacturer | Ross |
| Protocols | IP |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 70°C |
| Humidity | 5% to 95% non-condensing |
Provides contact methods and procedures for assistance with technical issues.
Lists key features and capabilities of the TES-8943 unit.
Outlines the available connections on the TES-8943 rear module.
Instructions for removing blank plates to prepare for module installation.
Instructions for connecting the TES-8943 to a network via Ethernet.
Details how to connect external devices using the SERIAL port.
Guides on assigning an IP address for DashBoard communication.
How to navigate and access card configuration and monitoring interfaces.
Step-by-step instructions for installing a software license key.
Guides on configuring the output video format for SDI signals.
Details how to connect and configure the Ethernet port for VANC data.
Describes the card's support for CEA-708 and CEA-608 closed captioning data.
Step-by-step guide to configure a TES Raw Data channel for encoding VANC data.
Guides on setting up the TES-8943 to decode VANC data packets.
Explains how GPIO ports function as inputs for triggering actions.
How to configure the serial port as a source for SCTE-104 messages.
How to configure GPIO ports for SCTE-104 encoding and decoding.
Details the settings for Linear Timecode (LTC) configuration.
How to monitor the status of ANC services during encoding via DashBoard.
Step-by-step guide for upgrading the TES-8943 software via DashBoard.
Describes the main interface displayed after launching DashBoard.
Details network settings and status information.
Details the technical specifications for the SDI input connections.
Details the technical specifications for the SDI output connections.
Procedure for performing a complete software reload on the card.
How to reset card parameters to their factory default settings.
Displays the terms of the GNU General Public License.
To Next Page