EasyManua.ls Logo

Ross USBPP2 - User Manual

Ross USBPP2
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
USBPP2 – Power Pack 2000 - (BLACK)
Model Number: USBPP2-RO
User Manual
Please read this manual thoroughly before using your Ross Power Pack and then retain for future reference
1.1 Important Safety Instructions:
Please read these instructions carefully and retain for future reference. If you sell, or give this aerial away be sure to pass on the instructions.
There are no user serviceable parts inside this unit. DO NOT open there are dangerous voltages inside. Electric shock hazard.
This unit operates on a 2000mAh capacity
During use, this device may become warm, this is normal.
The marking plate is located on the bottom enclosure of the apparatus.
DO NOT place naked ames (such as candles) on this equipment.
DO NOT operate close to heaters or other heat sources.
DO NOT stand on soft furnishings
DO NOT operate this unit in damp conditions or allow water or other uids to enter the enclosure. If this happens, switch o IMMEDIATELY
and refer the device to the Ross helpline.
DO NOT clean this device using solvent based products. Use only a soft dry cloth.
DO NOT leave this product in a hot or humid environment.
1.2 General Information
Thank you for choosing the Ross Power Pack 2000 (Black). Treated with care and used in accordance with the contents of this manual
it will provide many years of reliable service
This symbol indicates that, at the end of its useful life, this product must not be disposed of with normal domestic waste. To prevent
possible harm to the environment or human health from uncontrolled waste disposal, please recycle it responsibly.
This product conforms to all applicable EU legislation for this type of product. Further information can be obtained
from Ross if required.
2.0 In the Box:
Please open your box carefully and check the contents which
should be as the list below: If anything is missing please contact
the Ross helpline or return the product to the point of purchase.
Ross Power Pack
USB to Micro USB cable 30cm or 11.8 inches
User manual
3.0 Product Specications
Please nd the detailed specications for the Ross Power Bank below:
Real Capacity: 2000mAh
Input: 5V / 1A
Output: 5V / 1A
Battery: Lithium Polymer Battery
Weight: 60.5g
Dimensions (L*W*H) 61*71*12mm
Charging Time: 2.5 Hours
Static Power Consumption: 20µA
Cycle Life: > 500 Times
Question and Answer IconNeed help?

Do you have a question about the Ross USBPP2 and is the answer not in the manual?

Overview

This document describes the Ross USBPP2 Power Pack 2000, a portable external battery designed to charge various electronic devices.

Function Description:

The Ross USBPP2 Power Pack 2000 (Black) is a compact and lightweight portable power bank with a real capacity of 2000mAh. It serves as an instant portable power source, allowing users to charge their devices on the go by simply connecting them via the USB socket and pressing the power button. The device is equipped with an advanced intelligent protection chip that provides safeguards against overcharge, discharge, short circuit, and leakage, ensuring safe and reliable operation.

Important Technical Specifications:

  • Model Number: USBPP2-RO
  • Real Capacity: 2000mAh
  • Input: 5V/1A
  • Output: 5V/1A
  • Battery Type: Lithium Polymer Battery
  • Weight: 60.5g
  • Dimensions (LWH): 61mm * 71mm * 12mm
  • Charging Time: Approximately 2.5 hours (for the power bank itself)
  • Static Power Consumption: ≤20μA
  • Cycle Life: > 500 Times
  • Cable Included: 11.8" (30cm) Micro USB to USB charge cable

Usage Features:

  • Charging the Power Bank: To charge the power bank, connect the Micro USB end of the provided cable to the power bank's Micro USB input interface. Connect the USB end of the cable to an appropriate charging port, such as a USB wall plug or a laptop's USB input. The blue LED indicator lights will flash during charging and remain continuously on once fully charged. A full charge takes approximately 2.5 hours, though for the first-time charge, it may require 8-10 hours.
  • Charging a Device:
    • For Micro USB Devices: If your device uses a Micro USB connector, you can use the provided Micro USB to USB cable. Connect the Micro USB end to your device and the USB end to the power bank's USB 1.0A output interface.
    • For Other Connector Types (e.g., iPhone): Use the original charging cable supplied with your device. Connect the USB end of your device's cable to the power bank's USB 1.0A output interface, and the other end to your device.
    • After connecting, press the power indicator light button on the power bank. The charge icon on your device should then indicate that it is charging.
  • LED Indicators: The power bank features a 4-level LED indicator system that shows the remaining charge:
    • 4 LED Lights: 75-100% Power Capacity
    • 3 LED Lights: 50-75% Power Capacity
    • 2 LED Lights: 25-50% Power Capacity
    • 1 LED Light: 0-25% Power Capacity
    • Users can check the charge status at any time by pressing the power indicator button.
  • Device Charging Speed: The charging speed for your device will vary depending on its voltage requirements. For larger devices that require higher output, the power pack may extend battery life but might not fully recharge the device.
  • Portability: Its lightweight and compact design makes it easy to carry.

Maintenance Features:

  • Cleaning: The device should only be cleaned using a soft, dry cloth. Solvent-based products should not be used.
  • Storage: Avoid leaving the product in hot or humid environments.
  • USB Port Care: Ensure the USB ports on the device are kept clean. If cleaning is required, use a dry cloth.
  • Long-Term Storage: The product will lose charge if left unused for a long period.
  • Safety Precautions:
    • Do not open the unit, as there are no user-serviceable parts inside, and dangerous voltages may be present.
    • Do not place naked flames (e.g., candles) on or near the equipment.
    • Do not operate close to heaters or other heat sources.
    • Do not stand on soft furnishings that could obstruct ventilation.
    • Do not operate in damp conditions or allow water or other fluids to enter the enclosure. If this occurs, switch off immediately and contact the Ross helpline.
    • The device may become warm during use, which is normal.

General Information:

The Ross USBPP2 Power Pack 2000 is designed for long service life, offering more than 500 charging/discharging cycles. It conforms to all applicable EU legislation for this type of product. The product packaging includes the Ross Power Pack, a USB to Micro USB cable (30cm/11.8 inches), and a user manual. This product should be recycled responsibly at the end of its useful life and not disposed of with normal domestic waste.

Ross USBPP2 Specifications

General IconGeneral
BrandRoss
ModelUSBPP2
CategoryPower Supply
LanguageEnglish