Ross Video Ltd.
Part #: ###-###-##
Issue: #
Serial #: ########
#/#
USB 3.0
USB 3.1
3508DR-517-01 ©2023 Ross Video Limited, Ross®, and any related marks are trademarks or registered trademarks of Ross Video Limited. All other trademarks are the property of their respective companies.
PATENTS ISSUED and PENDING. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means,mechanical, photocopying, recording or
otherwise, without the prior written permission of Ross Video. While every precaution has been taken in the preparation of this document, Ross Video assumes no responsibility for errors or omissions. Neither is any liability
assumed for damages resulting from the use of the information contained herein.
1 Attach the handles to the front rack-mount tabs by aligning the handle with the round holes and
fastening from the rear with the supplied screws.
2
Use the supplied Rack Mount Kit to mount the XPression system in a 19’’ EIA equipment rack.
For information on installing the XPression chassis in a rack, see the provided document “Installing the
Chassis in a Rack”.
3 Plug the supplied Keyboard into a USB port.
4 Plug the supplied Mouse into a USB port.
5 Connect a Monitor (customer supplied) to any of the four display ports.
KVM extenders (customer supplied) are required when the XPression system monitor, keyboard, and
mouse are located remotely from the rack room.
6 Plug an Ethernet cable from your Local Area Network into one of the Ethernet ports.
XPression systems can run standalone or accept a connection to a production network. The network
connection is also used for the RossTalk / Smart GPI Feature.
7 Connect your house reference Genlock signal to the REF HD-BNC connector.
XPression systems accept analog blackburst or tri-level sync as reference inputs. Tri-level sync is
recommended for HD installations.
8
Connect the HD-BNC end of the pigtail cables to the HD-BNC
connectors and attach the SDI cables to the BNC end of the pigtails according to their required
destination (see the XPression User Guide or Help file for information about configuring the key and fill
for the HD-BNC connectors).
See page 2 for configuration instructions.
Not all HD-BNC connectors will be active depending on the XPression software edition. Keep any
unused pigtail and SDI cables in a safe place for future use.
If your facility requires analog outputs, additional outboard digital to analog conversion equipment is
available from Ross Video.
Inputs/outputs can be configured in the Hardware Setup in the
XPression User Guide or Help file.
9 Connect power cords from the AC Ports on the XPression system to the mains power.
XPression system power supplies are auto-sensing and can use either 110 VAC or
220 VAC.
Continued on other side...
1
1
4
3
6
5
7
12
11
10
9
8
7
6
5
4
3
2
1
8
9
CAUTION: Before you set up and operate this product, see the “Important Safety Instructions” in your Manual.
Getting Started
When contacting
technical support, please
provide the information
listed on this label.
To Next Page
Need help?
General
