Need help?Do you have a question about the Roswell Centurion Series and is the answer not in the manual?
Bolts and screws can loosen over time due to vibration. Check speaker bolts for tightness before use and re-apply red threadlock if loose.
Never hang off of the speaker under any circumstance to prevent damage or injury.
Be mindful of head clearance to prevent unnecessary head injuries when near speakers.
Be aware of your tow rope to avoid it getting wrapped around speakers or other objects.
Speakers can produce over 100 dB, potentially causing permanent hearing damage. Use safe listening practices.
Users should be mindful of surroundings as sound travels further over water.
Removable aftermarket covers can save time cleaning and protect speakers from damage during transit or storage.
Lists the components included in the package, such as speakers, wire connectors, spacers, and washers.
Details the necessary tools for installation, including Allen keys, screwdrivers, wire tools, and threadlocker.
Remove the trim rings by twisting counter-clockwise to access speaker mounting screws.
Remove and disconnect the main 8-inch rear speaker by undoing four screws.
Pull speaker wires out of the tower from holes under the speaker mounting plates.
Feed the wires from the tower into the center hole of each speaker mount spacer.
Mount speaker housings using plastic spacers and hardware, applying red thread locker to bolts.
Connect speaker wires using provided connectors, crimping and heat shrinking them as per the wiring chart.
Reconnect the main rear facing speaker and reassemble the speaker and trim ring onto housings.
Assemble the trim ring back onto the speaker housings to complete the installation.
To Next Page
General