A
B
Remove the 4 rubber plugs from the bimini mounts
on your tower. These are press fit into the bimini
mounts and do not require any tools to remove.
Rubber
Plugs
Preparing your tower
Installing Bimini Arms
Bimini
Mounts
x4
Remove the 2 bimini arms from your box. Carefully unwrap them. Assemble the bimini arms to the tower using
the 8 washers and 4 bolts from the box. Apply red Loctite to all 4 bolts and assemble the arms as illustrated. Do
not fully tighten down the arms yet, they need to be loose for the next installation step.
Bolt Washers
THREADLOCKER
5/16"
C
Position arms as illustrated,
then tighten down the bimini
arm bolts that were loosely
installed in Step B.
Tighten Bimini Arm
Bolts
5/16"
**IMPORTANT**
Tighten the Rear
Bolts at the top of the
slots as illustrated.
Port Bimini Arm
Starboard Bimini Arm
Torque bolts to 40ft.lbs
Bolts
x4
07
Moomba Tower Bimini
www.roswellmarine.com
Paint Protection
Washers
x4
To Next Page