2
SUMMARY
GENERAL DESCRIPTION __________________________ 3
SYMBOLS USED IN THE MANUAL __________________ 4
PLATES LOCATION DRAWING ______________________ 5
1.0 GENERAL INTRODUCTION ___________________ 7
1.1 Introduction __________________________________ 7
2.0 INTENDED USE ____________________________ 7
2.1 Training of personnel ___________________________ 7
3.0 SAFETY DEVICES ___________________________ 8
3.1 Residual risks _________________________________ 8
4.0 IMPORTANT SAFETY INSTRUCTIONS __________ 8
4.1 General safety rules ____________________________ 9
5.0 PACKING AND MOBILIZATION FOR TRANSPORT 10
6.0 UNPACKING _____________________________ 10
7.0 MOBILIZATION ___________________________ 11
8.0 WORKING ENVIRONMENT CONDITIONS _______ 11
8.1 Working position _____________________________ 11
8.2 Working area ________________________________ 11
8.3 Lighting ____________________________________ 12
9.0 EQUIPMENT ASSEMBLY ____________________ 12
9.1 Anchoring system ____________________________ 12
9.2 Assembly procedures _________________________ 13
9.3 Electrical connections _________________________ 15
9.4 Oil check on oil-pressure power unit ______________ 16
9.5 Check of motor rotation direction ________________ 16
9.6 Electrical checks _____________________________ 16
10.0 CONTROLS ______________________________ 17
10.1 Control device _______________________________ 17
11.0 USE OF THE EQUIPMENT ___________________ 18
11.1 Precaution measures during tire removal and fitting __ 18
11.2 Preliminary operations _________________________ 18
11.3 Preparing the wheel __________________________ 18
11.4 Wheel clamping ______________________________ 18
11.5 Bead breaker arms’ functioning__________________ 20
11.6 Tubeless tires ________________________________ 20
11.6.1 Bead breaking ____________________________ 20
11.6.2 Demounting ______________________________ 21
11.6.3 Mounting ________________________________ 22
11.7 Tires with inner tube __________________________ 24
11.7.1 Bead breaking ____________________________ 24
11.7.2 Demounting ______________________________ 24
11.7.3 Mounting ________________________________ 25
12.0 ROUTINE MAINTENANCE ___________________ 26
13.0 TROUBLESHOOTING TABLE _________________ 29
14.0 TECHNICAL DATA _________________________ 31
14.1 Technical electrical data _______________________ 31
14.2 Technical mechanical data _____________________ 31
14.3 Dimensions _________________________________ 32
15.0 STORING ________________________________ 33
16.0 SCRAPPING _____________________________ 33
17.0 REGISTRATION PLATE DATA _________________ 33
18.0 FUNCTIONAL DIAGRAMS ___________________ 33
Drawing number A - Wiring diagram____________________ 34
Drawing number B - Hydraulic diagram _________________ 40
To Next Page
Loading...