9
English
FM RADIO
Before listening to FM radio, make sure that the FM antenna have been
properly connected.
FM Radio Station Playing
1. Select FM Button from the source buttons 6N. The display will show
as below
95.25MHz
[No RadioText]
2. Turn the knob 8 to change the frequency of radio station. Turning it
up or down one step at a time changes the frequency one step. Turning
it faster and the unit will scan for stations.
3. Use the UP/DOWN keys on the remote to manually search for FM
stations.
4. Press and hold the UP/DOWN keys on the remote to auto scan for
FM stations.
Storing a radio station in a preset
While a radio station is playing, push the memory button 9I, then
press the number of preset assigned from the numeric pad 4H, the
display will show preset saved. Up to 30 preset FM radio stations may
be stored.
Playing a preset radio station
When a radio station is playing, you can switch to a preset station in
one of the following ways.
1. From the numeric pad 4H, press the preset number of the desired
station.
2. Press PRESET +/- K on the remote to call out preset numbers and
corresponding station. Also, you can press the UP/DOWN keys to select
the desired station, then press the ENT key to select. Press FM 6N button
again to exit the preset menu and back to playing status.
3. Press the FM 6N button. This toggles between the following 3
selections
1. Display FM station currently tuned to.
2. Display Preset Menu.
3. Display FM settings Menu
Toggle to the Preset Menu and scroll through all the presets with the knob
8 Press the ENTER 0 key to select.
From the remote, use the +/- PRESET K keys to select a PRESET and
press the ENT key to select.
FM Settings Menu
Press the FM 6N button and toggle to the FM settings Menu. There
are 3 sub-menu under FM setting
1. Scan Settings - Select between ALL STATION or Strong Stations
Only.
2. Audio Settings - Allow Stereo or Forced Mono
3. System - Select Factory default and shows the current software.
To make changes in the FM settings menu, turn the knob 8 on the front
panel or the UP/DOWN keys on the remote. To make a change press
the Enter 0 key on the front panel. From the remote control, press the
ENT key.
To Next Page
Loading...
