What to do if the Rotex Inverter contactor is not triggered and fault codes are displayed?
If the Rotex Inverter contactor is not triggered, fault codes are displayed and the Operation LED flashes, look for causes and remedy them. To unlock the system, switch it off manually to reset the fault code and then start it again.
What to do if Rotex HPSU compact 516H Inverter contactor is triggered?
If the contactor is triggered, find out the cause of triggering the contactor and remedy the fault. Then, start up the system again.
What to do if Rotex HPSU compact 516H contactor is not triggered but the system isn't working?
If the contactor is not triggered, no fault codes are shown but the system is not working properly, look for causes and remedy them.
Details safety requirements for authorized personnel, electrical work, and operating procedures.
Outlines the system's components, including the external unit and internal HPSU compact, with an overview diagram.
Explains how to use the main control unit for system operation, configuration, and mode settings.
Details all parameters for the main control unit, including setting procedures and descriptions.
Explains how the system detects faults and provides initial troubleshooting steps.
Lists common malfunctions, their possible causes, and solutions.
Details specific fault codes generated by the system, their component designation, and possible causes.
To Next Page
General