Rothenberger ROTHERM 2000

Questions and Answers

J
jessicabrownAug 7, 2025
What to do if the red “Input Voltage“ LED doesn't light up on my Rothenberger Battery Charger?
- A
  Allen PetersAug 7, 2025
  If the red “Input Voltage“ control LED on your Rothenberger Battery Charger doesn't light up, it could be due to several reasons. First, check the power supply to ensure it is providing voltage. If the power supply is working, inspect the mains cable for any damage and replace it if necessary. Another possibility is a defective red control LED, which would need replacement. Lastly, check the fuse in the main unit and replace it if it's defective.
V
vbakerAug 13, 2025
What to do if the red “Input Voltage“ LED doesn't light up on my Rothenberger Soldering Gun?
- D
  Darrell FoxAug 13, 2025
  If the red “Input Voltage“ control LED on your Rothenberger Soldering Gun does not illuminate, here are a few things to check: * First, ensure that the power supply connection is properly connected. * Next, inspect the mains cable for any signs of damage; if damaged, replace it. * The red control LED may be defective and need replacement. * Lastly, the fuse in the main unit could be defective, requiring replacement.
R
Robyn BaileyAug 22, 2025
Why is the green control LED not lighting up on my Rothenberger ROTHERM 2000?
- M
  Michael HendersonAug 22, 2025
  If the green control LED on your Rothenberger Soldering Gun isn't lighting up, here's what might be happening: * The pneumatic circuit may not be activated; try activating it. * The air intake to the pneumatic circuit could be blocked. Make sure it's clear. * A vacuum might have developed in the air intake; check for and relieve any vacuum. * The overload protection may have temporarily switched off the unit. Try resetting the overload protection after allowing the unit to cool down.
J
Joe BradshawAug 29, 2025
What to do if the red “Input Voltage“ control LED does not light up on Rothenberger ROTHERM 2000 Soldering Gun?
- J
  Jessica MurphyAug 30, 2025
  If the red “Input Voltage“ control LED on your Rothenberger Soldering Gun doesn't light up, the possible causes are: no input voltage, defective mains cable, defective red control LED, or a defective fuse in the main unit. To resolve this, first check the mains power supply. If that's not the issue, inspect and replace the mains cable. If the problem persists, replace the red control LED. Finally, check and replace the fuse in the main unit.