What to do if drive chains are breaking on Roto-Mix Farm Equipment?
If the drive chains on your Roto-Mix Farm Equipment are breaking, first align the sprockets. Chain breakage may also occur due to the chain riding up on the sprocket teeth; in this case, refer to possible remedies for 'Chains Jumping Sprocket Teeth'. Also, consider that excessive loads can cause this issue.
Why is there vibration or growling in the rear structure of my Roto-Mix Hay Pro Farm Equipment?
If you experience vibration or growling in the rear structure of your Roto-Mix Farm Equipment, check and realign the drive sprockets and universal joints if they are out of line. Also, a worn-out bearing could be the cause, so consider replacing it.
What to do if chains are jumping sprocket teeth on Roto-Mix Farm Equipment?
If the chains are jumping sprocket teeth on your Roto-Mix Farm Equipment, first adjust the idlers. If the issue persists, check and realign the drive sprockets if they are out of line. Lastly, inspect the sprocket teeth for wear and replace the sprocket if needed.
Why is there excessive bearing failure in my Roto-Mix Hay Pro Farm Equipment?
Excessive bearing failure in Roto-Mix Farm Equipment can be due to improper lubrication, so refer to the lubrication chart. Another cause could be contamination, in which case you should check the seal and replace it if necessary. Excessive loads may also be a factor.
How to prevent excessive shearing of power shaft shear pin on Roto-Mix Farm Equipment?
Excessive shearing of the power shaft shear pin on your Roto-Mix Farm Equipment can occur due to high-speed engagement of the PTO or conveyor, so decrease the engine RPM before engaging the PTO or lowering the discharge chute on the trailer. It can also happen due to excessive loads.
General| Brand | Roto-Mix |
|---|---|
| Model | Hay Pro Series |
| Category | Farm Equipment |
| Language | English |
To Next Page