Do you have a question about the Roto Spa Spas and is the answer not in the manual?
Key safety warnings including child supervision, grounding, drowning risk, electric shock, and water temperature limits.
Additional safety guidelines covering temperature measurement, alcohol/drug use, and health considerations.
Safety instructions specific to CSA standards, covering electrical grounding and bonding requirements.
Covers child supervision, medication use, health conditions, pregnancy, and infectious diseases.
Addresses suction guards, entry/exit, alcohol/drugs, temperature checks, exercise, and immersion duration.
Warning against placing electric appliances within 1.5m of the spa.
Caution to maintain water chemistry as per manufacturer's instructions.
Explains hyperthermia causes, symptoms, effects (drowsiness, inability to exit, fetal damage, drowning).
Warns that alcohol, drugs, or medication can increase the risk of fatal hyperthermia.
Maintain water level above skimmer height; low level voids warranty and risks overheating.
Always turn off power before draining/filling; do not use extension cords; use GFCI.
Maintain proper pH (7.4-7.6); high pH can damage heater and void warranty.
Install on water-resistant surfaces, avoid reflective objects, protect from direct sunlight, do not open controller.
Choose a structurally strong, smooth, level, well-drained site with easy access to equipment.
Place on firm, level, well-drained base; use stepping-stones for grass/dirt entry.
Ensure good drainage, use proper building materials, consider humidity and ventilation.
Homeowner responsibility for a suitable, level foundation; avoid grass/dirt.
Verify deck load capacity; consult professionals for heavy spas.
Use 110V 15amp cord with inline GFCI, avoid extension cords to prevent shock/fire.
Caution not to operate without water; avoid soft water; follow start-up steps.
Steps for filling the spa, checking connections, and powering up the system for diagnostics.
Default temperature is 95F; adjust using the control panel buttons.
How to use the 'Pump' key to turn the pump on/off and change speeds.
Procedure to set the duration of the filtering cycle using the 'Light' and arrow keys.
Steps for winterizing the spa, including draining, disconnecting unions, and vacuuming water.