EasyManua.ls Logo

RotoSpa DuraSpa S160 - User Manual

RotoSpa DuraSpa S160
17 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...

Table of Contents

Questions and Answers

  • U
    upaceAug 2, 2025
    What to do if Error 6 is showing on RotoSpa Hot Tub?
    • S
      shawnjamesAug 3, 2025
      If Error 6 appears on your RotoSpa hot tub's control pad, first let the water cool below 38°C. Then, reset the hot tub by pressing the up, down, and pump buttons simultaneously. If the error persists, check if all jets are fully open, ensure your filters are clean, and verify the water level is correct. After each check, reset the RotoSpa. The error could be due to an air lock, blockage, too many closed jets, or a dirty filter.
  • Z
    zrobinsonAug 10, 2025
    Why is my RotoSpa DuraSpa S160 pump so noisy?
    • L
      lawrencecourtneyAug 10, 2025
      If your RotoSpa hot tub pump is louder than usual, it might be due to a pump fault or insufficient water. Check that the water levels are correct. Also, consider if you've recently moved the hot tub; enclosure in a cabin or placement on decking can amplify pump noise.
  • S
    Shari TrujilloAug 17, 2025
    What does H2O error mean on RotoSpa DuraSpa S160 Hot Tub?
    • R
      roy89Aug 17, 2025
      The H2O error message on your RotoSpa indicates that no water is being detected in the heater. This could be due to an air lock, a fault with the optical sensor, water that is too pure, or an obstruction of the optical sensor due to hard water.
  • T
    Theresa LittleAug 25, 2025
    Why is my RotoSpa Hot Tub making a sucking sound?
    • M
      Mark KellerAug 26, 2025
      A sucking sound or surging in your RotoSpa hot tub indicates that the water level is too low.

Summary

Introduction

Electrical Supply

Getting Started

Initial Setup and Chemical Balancing

Guide on filling, heating, pH balancing, and adding sanitiser for the spa.

Control Panel and Features

Maintenance

Filter Maintenance

Instructions on cleaning, maintenance, and replacement of hot tub filters.

Water Balance and Chemicals

Guidance on pH, sanitiser levels, and additional chemicals for water quality.

Water Quality and Draining

Troubleshooting Water Issues

Addressing murky water, green water, smells, and sediment buildup.

Water Change and Drain Down Procedures

Steps for draining, refilling, and winterizing the hot tub.

DuraSpa S160 Specifications

Health and Safety

Troubleshooting

Control Panel Error Codes

Solutions for common error messages like Error 6 and H2O on the control display.

Operational Problems

Addresses issues like noisy pumps, sucking sounds, leaks, and reduced jet flow.

RotoSpa DuraSpa S160 Specifications

General IconGeneral
Dimensions200cm x 200cm x 86cm
Water Capacity980 Litres
Pump Power1.5 HP
Heater3kW
MaterialAcrylic
Voltage230V
Air JetsNot applicable

Related product manuals