5
No Diving or Jumping. Observe all Safety Rules.
3-5
Hint:
If possible, unfold the liner
on the grass one to two
hours before installation.
Be careful not to leave
the liner too long or you
may damage the grass.
Hint:
The liner is generally
smaller than the support
structure of the pool. It
will stretch more easily
when warm. It is important
that the liner is installed on
a warm sunny day.
B. Install your Pool
Liner
1. Set the liner in place
a. Open the carton. Do not use any-
thing sharp to open the carton.
b. Unpack and unfold the liner and
spread it out in the sun to warm it
up. Inspect all the seams and sur-
faces for holes.
c. Spread out the liner, smooth side
down. The curved seam should be
centred on the cove at the base of
the wall. The other seams will form
straight lines across the bottom of the
pool.
d. Smooth out all the wrinkles in the
bottom.
2. Fasten the Liner in place
(Overlap Liner only)
This step applies only if you have an
Overlap Liner. See the next page if
you have a Beaded Liner or V-Bead
Liner.
a. Starting at the liner wall seam,
hang the liner over the wall mak-
ing sure that the seam is straight
up and down, perpendicular to the
oor. (Remove stabilizers gradually
as you fold the liner over the top of
the wall. )This will assure you that
the liner begins going over the wall
straight.
15
16
16a
16b
To Next Page
Loading...