INTRODUCTION
INTRODUCTION 1
INTRODUCTION
How to use this Manual
To assist in the use of this Manual the section title is
given at the top and the relevant sub-section is given
at the bottom each page.
Each major section starts with a contents page,
listing the information contained in the relevant
sub-sections. To assist filing of revised information
each sub-section is numbered from page 1.
The individual items comprising repair operations
are to be followed in the sequence in which they
appear. Items numbers in the illustration are referred
to in the text.
Adjustment and repair operations include reference
to Service tool numbers and the associated
illustration depicts the tool. Where usage is not
obvious the tool is shown in use. Adjustment and
repair operations also include reference to wear
limits, relevant data, torque figures, and specialist
information and useful assembly details. Each
adjustment or repair operation is given its Repair
Operation Time number. WARNINGS, CAUTIONS
and NOTES have the following meanings:
WARNING: Procedures which must be
followed precisely to avoid the possibility
of injury.
CAUTION: Calls attention to procedures
which must be followed to avoid damage
to components.
NOTE: Gives helpful information.
References
References to the LH or RH side given in this
Manual are made when viewing the vehicle from the
rear. With the engine and gearbox assembly
removed, the crankshaft pulley end of the engine is
referred to as the front.
Operations covered in this Manual do not include
reference to testing the vehicle after repair. It is
essential that work is inspected and tested after
completion and if necessary a road test of the
vehicle is carried out particularly where safety
related items are concerned.
Dimensions
The dimensions quoted are to design engineering
specification with Service limits where applicable.
To Next Page
Loading...
