Cruise control
106
To reduce the cruising speed
Use the brake pedal to slow the vehicle, until
the required speed has been reached, then
press the ’SET+’ switch to establish a new
cruising speed. Remember that cruise control
will not operate at speeds below 28 mph (45
km/h).
Alternatively, briefly press the ’RES’ switch
once to cut off cruise control; if the brake
pedal is not used, the vehicle will slow down
gradually. When the desired speed has been
reached, press the ’SET+’ switch to establish
the new cruising speed.
To increase the set cruising speed
Press and hold the ’SET+’ switch; the vehicle
will accelerate automatically. Release the
switch as soon as the desired speed has been
reached.
Alternatively, the set speed can be increased
incrementally, by ’tapping’ the ’SET+’ switch.
For each five taps, the speed will increase by 5
mph (8 km/h).
Disengaging cruise control
Cruise control will automatically disengage if
the brake pedal is pressed, or when the gear
selector lever is moved into ’N’.
Alternatively, briefly press the ’RES’ switch
once to cut off cruise control; this allows the
vehicle to slow down gradually.
If required, press the ’RES’ switch again to
re-engage cruise control at the previously-set
speed.
NOTE: The speed held in the cruise control
memory will be cancelled, when either the
cruise control master switch, or the starter
switch, are turned off.
NOTE: Cruise control will disengage
automatically, if your road speed falls to less
than 75 per cent of the set speed (this could
occur when towing uphill).
To Next Page
Loading...
