6
E
N
(*) Depending on model
Problems Cause Solution
The iron is plugged
i
n, but the soleplate
of the iron remains
c
old.
No mains supply. Check that the mains plug is properly
i
nserted or try plugging the iron into a
different socket.
Temperature control set too
l
ow.
Set the temperature control to a higher
t
emperature.
The automatic electronic
c
ut-off* is active.
Move your iron.
If you have any product problems or queries please contact our Customer Relations Team first
for expert help and advice:
0845 602 1454 - UK (01) 677 4003 - Ireland or consult our wesbite - www.rowenta.co.uk
Subject to modifications !
B
rown streaks
come through the
h
oles inthe
soleplate and stain
the linen.
None or too little
s
team is being
emitted.
Residues in the steam
c
hamber or on the soleplate.
Use the Self Clean function then clean
y
our iron.
A
nti-Drip is active
(
§ 9).
W
ait for the soleplate to reach the
c
orrect temperature.
N
ot enough water in the
water tank.
F
ill the water tank.
S
team control set on dry
position .
T
urn the steam control to the required
setting area.
U
se of chemical descaling
agents.
D
o not add any descaling agents to the
water in the water tank. Use the Self
C
lean function and clean your iron.
Fabric fibres have
accumulated in the holes of
the soleplate and are
burning.
Clean the soleplate with a non-metallic
sponge.
Vacuum the holes of the soleplate from
time to time.
Your linen is not rinsed
sufficiently or you have
ironed a new garment
before washing it.
Ensure linen is rinsed thoroughly to
remove any soap deposits or chemicals
on new garments which may be sucked
by the iron.
Use of starch. Always spray starch onto the reverse
side of the fabric to be ironed and clean
your iron soleplate.
Pure distilled /
demineralised or softened
water is being used.
Only use untreated tap water or mix
half tap water with half
distilled/demineralised water. Use the
Self Clean function and clean your iron.
Iron is leaking.
Overuse of shot of steam
button.
Soleplate temperature too
low .
Set the temperature control to a higher
temperature.
Allow more time between each shot.
PROBLEMS?
1103909964-index 02 DW6000 D1.qxp_110x220mm 08/02/16 13:31 Page6
To Next Page
Loading...
