10
INSTALLATION
1 Remove the air inlet grid.
3 Remove the protective lm
of the particle lter.
5 Install the pre-lter.
Align the slot position at the bottom, and
buckle up the upper U-shaped buckle.
6 Install the air inlet grid.
Align the upper two buckles and
press them tightly, then press the
two sides at lower part, slowly and
gently buckle the air inlet grid.
4 Install the particle lter.
2 Take out the pre-lter.
Press the raised part on both sides
to pull it outwards, and take out the
pre-lter.
Buckle
Buckling
position
To Next Page
Loading...
