EN
8
OPERATING INSTRUCTIONS
This unit has 2 operation types (manual or automatic) and various additional functions.
• “ON/STANDBY”: On/Standby (off); Button A.
Press button (A) to turn the unit on or to put it on standby.
MANUAL FUNCTION
Setting the target humidity level and mist output rate
• Humidity level: Setting the target humidity level; Button C.
Choose the desired target humidity level by repeatedly pressing button C.
When SELECT appears, the humidity level that is displayed is the target rate that you have set:
between 40% and 75% relative humidity (RH) or "Co" for continuous operation (a safety shut-
down system will shut the unit down if the room humidity level exceeds 90% RH).
When "HOME" is visible without SELECT, the humidity level displayed is the humidity level of the
room at the level of the unit.
NOTE: This setting cannot be used in “Smart" modes.
WARNING: A very high humidity level in the room, in continuous operation mode, can affect the
air quality and can damage some objects. The recommended optimal humidity level is between
50% and 60% RH.
• Mist output speed - Setting the mist output speed; Button F.
Choose the desired mist output speed by repeatedly pressing button F. Three speeds are available.
NOTE: This setting cannot be used in “Smart" modes.
AUTOMATIC FUNCTION
Using the 3 pre-set operating modes
• SMART MODES: Selection of pre-set operating modes; Button E.
Choose one of three pre-set modes by repeatedly pressing button E.
AUTO mode: Automatic operation of the unit is pre-set to a target humidity level of 55% RH; the
unit automatically adjust the mist output rate according to the humidity of the room.
BABY mode: Automatic operation of the unit is pre-set to a target humidity level of 50 % RH; the
unit automatically adjust the mist output rate according to the humidity of the room. After 7
hours of operation the unit will stop automatically.
NOTE: Lights and beeps are disabled in this mode.
NIGHT mode: Automatic operation of the unit is pre-set to a target humidity level of 50% RH; the
unit will gradually reduce the mist output rate. After 8 hours of operation the unit will stop auto-
matically.
NOTE: Lights and beeps are disabled in this mode.
ADDITIONAL FUNCTIONS
• Timer: Programming the unit’s automatic shutdown; Button B.
Choose the desired number of hours of operation (from 1 to 9 hours) before the unit automati-
cally shuts down by repeatedly pressing button B.
NOTE: This function cannot be used in “Smart" modes.
• Heating function: Using the heating function; Button D.
Press button (D) to start or stop the “heating” function.
To Next Page
Loading...