17
Before first use
• When you first use the appliance, some smoke or a harmless odour may be produced or there
may be a small discharge of particles. This will not affect the use of the appliance and will
disappear quickly.
What water to use?
• Your appliance has been designed to use tap water.
If your water is very hard, mix 50% tap water and 50% bottled demineralised water.
Never use water containing additives (starch, perfume, aromatic substances, softeners, etc.), or
condensation water (for example water from tumble dryers, water from refrigerators, water
from air conditioning units, rainwater). This water contains organic waste materials or minerals
that concentrate
under the effect of heat and cause spitting, brown colouring or premature ageing of
your appliance.
SAVE THESE INSTRUCTIONS
Environmental protection first!
i Your appliance contains valuable materials which can be recovered
or recycled.
When disposing of it, take it to a local civic waste collection point.
DESCRIPTION
1. Steam head
2. Steam head hook
3. Built in hanger
4. Rotary trouser/dress clips
5. Hanger holder
6. Roll & press system: vertical support
panel
7. Roll & press system: rolling and
locking handle
8. Roll & press system: locking hook
9. Hanger fastening screw
10. Pole locking clips
11. Telescopic pole
12. Electric cord holder
13. Electric cord
14. Velcro strip
15. Pole fastening screw
16. Steam hose connector
17. Removable water tank
18. ON/OFF pedal
19. Transport wheels
20. Textile steam hose
21. On/ off light
22. Built in accessories
a. Fabric brush
b. Lint pad
c. Delicates steam cap
BEFORE USE
1 • Garment steamer assembly
Pole assembly
1. Unscrew the fastening screw on the base of the pole (fig. 1).
2. Hold the pole such that the cord holder is on the left. Check that the 2 pole clips are
unlocked (fig. 2).
3. Insert the pole into the base by pressing downwards until the holes of the pole and
base are at the same level, so that you can put the screw back. If the holes are not
aligned, check that the clips of the pole are well and truly unlocked (fig. 3).
4. Screw the pole fastening screw back in as far as it will go so that the pole is firmly
fixed to the base (fig. 4).
5. Adjust the pole to its maximum height by sliding it upwards (fig. 5) then locking the 2 clips
(fig. 6). Make sure the 3 segments of the pole are fully extended.
9100021244-01 IS6300 D1.indd 17 11/07/2016 09:42
To Next Page
Loading...
Need help?
General
