6 7
care not to create short circuits in the batteries
by inserting metal objects at their ends. If a short
circuit occurs, the battery temperature may rise
dangerously and can cause serious burns or
even catch re. If the batteries leak and in case
of contact, do not rub your eyes or any mucous
membranes. Wash your hands and rinse your
eyes with clean water. If the discomfort persists,
consult your doctor.
• WARNING - The battery used in this appliance
may present risk of re or chemical burn if used
incorrectly. It should not be disassembled,
short-circuited or stored at < 0°C and > 45°C or
incinerated. Keep out of the reach of children. Do
not disassemble it or throw it in re.
• If the appliance is to be stored unused for a long
period, the batteries should be removed
ENVIRONMENT
In accordance with existing regulation, any end-of-life appliances must be taken to an approved Service Centre
which will take responsibility for managing their disposal.
Let’s help protect the environment.
Your device is designed to work for many years. But when you decide to replace it, don’t
forget to think about how you can help protect the environment by allowing it to be reused,
recycled or recovered in some other way. Waste electrical and electronic equipment may
contain harmful substances that can cause harm to the environment and human health.
This label indicates that this product must not be disposed of with household
waste. Take it to a collection point, to the distributor when buying a
new equivalent product, or an approved service center for processing.
Before disposing of the device, remove the battery and dispose of it in accordance with local laws
and local arrangements. If you have any questions, please contact your product dealer who can
tell you what to do.
PROBLEMS WITH YOUR APPLIANCE ?
Depending on model :
PROBLEMS POSSIBLE CAUSES SOLUTIONS
The charger becomes hot.
This is perfectly normal. The vacuum
cleaner can remain permanently
connected to the charger without
any risk.
The charger is connected but your
appliance is not charging.
The charger is not properly connected
to the appliance or is faulty.
Check that the charger is properly
connected or contact an Approved
Services Centre to change the charger.
Your appliance stops during operation
and the light/s flash very quickly.
Your appliance may be overheating.
Stop the appliance and leave cool for
at least 1 hour.
The appliance has stopped after the
charge light ashed.
The appliance has lost its charge. Recharge the vacuum cleaner.
The power-brush is not working
properly or makes a noise.
The rotating brush or hose are
obstructed.
Stop the vacuum and
clean the parts.
The brush is worn.
Contact an Approved Service Centre
to change the brush.
The belt is worn.
Contact an Approved Service Centre
to change the belt.
The power-brush stops during use of
the vacuum cleaner.
The heat safety device
has come on.
Stop the vacuum cleaner. Check that
nothing is obstructing the rotation of
the brush; if there is an obstruction,
remove it and clean the power-brush,
then turn on the vacuum cleaner.
Your vacuum cleaner suction is not
working properly or is making a
whistling noise.
The tube or hose is partially blocked. Unblock them the tube/hose.
The dust collector is full. Empty it and clean it.
The dust collector is not properly tted.
Re-position it correctly.
The suction head is dirty. Remove the power-brush and clean it.
The foam motor protection
lter is full.
Clean it.
When charging the vacuum cleaner,
the light(s) ash very quickly or the
red light is on.
The correct charger is not being used
or the charger is faulty.
Talk to an Approved Service Centre to
change the charger.
The red LED on the product ashes
during use
The suction head brush is blocked.
Stop vacuuming and check that there
is nothing blocking the rotation of the
brush.
The battery temperature is too high.
Leave the product to rest for 30minutes.
If the problem persists, replace the
battery.
The tube and/or suction head
connectors are dirty or damaged.
Clean the tube and suction head
connectors with a cloth.
The suction motor is not working.
Contact an Approved Service Centre to
have your appliance repaired.
Please keep this user manual.
EN