Rowenta X-O 90 - First Use and Power Management; Pre-Use Instructions; Vacuum Power Modes; Power Button Operation

ECO
MAX
BOOST
HIGH
ECO
MAX
BOOST
HIGH
BEFORE THE FIRST USE
Pair your remote control before the rst usage. This will take
you approximately 10 seconds and must be done only once.
Take off the plastic tab before the st use.
1. Switch on your appliance using the
Power button (picture below).
2.
Press simultaneously and shortly MAX
and PAUSE buttons to enter the pairing
mode -> product LED lights will blink to
conrm pairing mode.
3.
Press PAUSE button to confirm the
pairing -> product LED lights will
stop blinking and you will hear the
conrmation beep.
Congratulations! You have successfully
paired your remote control.
If pairing failed within 10 seconds, please switch off your appliance.
Then go back to step 1 and follow the instructions for re-pairing.
POWER MODE
Your appliance has 4 power modes for different tasks. Change
cleaning modes using your remote control buttons and adjust
the power:
The LEDs indicate the
power modes.
In BOOST mode, all
three green lights will
ash on simultaneously.
BOOST: 5min
Intensive cleaning for ground-in-dirt.
NB: Keep pressing the BOOST button to use this
mode .
MAX: 20/40min*
Intensive cleaning and encrusted dust. Ideal
on all types of carpets.
HIGH: 40/50/90min*
For maintenance cleaning. Ideal for all types
of hard oors.
ECO : 1h10/1h30/2h40min*
For lightly soiled oors and delicate surfaces :
shelves, frames, curtains etc.
PAUSE:
Temporary shutdown during use.
POWER BUTTON ON/OFF
To turn on and off your
appliance, press shortlu the
Power button.
To start vacuuming, press on
ECO, HIGH or MAX speed on
your remote.
66
QUICK START GUIDE
EN
*depending on model.
ROWENTA_XO_IFU_NOTICE.indd 67ROWENTA_XO_IFU_NOTICE.indd 67 05/05/2021 16:5805/05/2021 16:58