What to do if my Rowi HIH 2000/ 1/1 Heater does not start?
If your Rowi Heater doesn't start, first ensure the connector is properly plugged into the socket and check the power supply voltage. Also, make sure the heater is switched on by turning the heating level switch to position "I" or "II".
Why does my Rowi HIH 2000/ 1/1 switch off during operation?
Your Rowi Heater might be switching off during operation because the room temperature is above the set thermostat temperature. Increase the thermostat temperature. If overheating is the issue, switch off the appliance, unplug it, let it cool down, and check/remedy any air inlet/outlet blockages before restarting.
How to fix a Rowi HIH 2000/ 1/1 Heater that won't start?
If your Rowi Heater won't start, check that it's properly plugged into the socket and that the power supply voltage is correct. Also, ensure the heater is switched on by setting the heating level switch to either position "I" or "II".
Safety rules marked with this symbol must be strictly observed at all times.
Denotes important information that must be strictly observed for fault-free operation.
Provides explanatory information and tips to help use the appliance optimally.
Portable, powerful electric heater for diverse applications like building trade, agriculture.
The type plate with technical data is attached on the side of the control unit.
Constructed according to state of the art; improper use can cause hazards.
Details safety devices like overheating protection.
Lists power supply, max. heat output, heating stages, degree of protection, dimensions, weight.
Check for completeness and defects immediately after opening packaging.
Keep original packaging for storing and transporting the appliance.
Operate in a secure and stable position with required minimum distances.
Shows a diagram labelling key components like carrying handle, control unit, air outlet.
Details connecting the heater and switching it on via the heating level switch.
Explains how to set desired heating power and temperature using controls.
Step-by-step guide to turn off the appliance, including fan run-on time.
Protect appliance against dust, dirt, and insects during storage.
Pack appliance in original packaging for transportation to prevent damage.
Pull mains plug and ensure appliance has cooled down before servicing.
Appliance should be covered after each use to prevent contamination.
Note that only original parts may be used for repair and maintenance work.
Lists faults, possible causes, and remedies for common appliance issues.
Maintenance not listed may only be done by ROWI Service Centre; unauthorized work voids warranty.
Details the 24-month warranty period and exclusions like improper use or wear.
Steps to follow if problems occur, including reading instructions and filling service form.
Provides contact information for the ROWI Service Team via mail.
Steps for returning the appliance for inspection or repair, including packing and documentation.
Diagram showing disassembled parts with item numbers for the HIH 2000/1/1 model.
Lists spare parts, designations, and article numbers for HIH 2000/1/1.
Lists spare parts, designations, and article numbers for HIH 3000/2/1.
Lists spare parts, designations, and article numbers for HIH 9000/2/1.
Instructions for environmentally friendly disposal within the EU, avoiding household waste.
Provides the electrical circuit diagram for the HIH 2000/1/1 model.
Provides the electrical circuit diagram for the HIH 3000/2/1 model.
Provides the electrical circuit diagram for the HIH 9000/2/1 model.
Lists conditions and applications not covered by the guarantee.
To Next Page
General
