Rowkin BIT MICRO TOUCH - Page 6

3. SYNC & PAIR YOUR EARBUDS
User Manual
For Subsequent Use:
• To Power ON: Simply take the earbuds out of
the case.
• To Power OFF: Place in the case. OR hold the
button for 5 seconds until you hear “Power Off".
Wait for
6-8 sec.
Wait
5 sec.
Primary
(Right Channel)
Primary
(Right Channel)
1. Take earbuds out of
case and place next to
each on a flat surface.
Be sure to place on
the ear tip or on the
side so you can see
the LEDs. Do not place
upside down.
2. The Red LED will
be lit for 5 seconds.
While syncing, both
earbuds will flash
white.
3. Once the
earbuds are synced
to each other, the
Right earbud will
flash red and white
to indicate it has
entered pairing
mode.
4. Go to Bluetooth
settings on your
device and select
“Rowkin Bit Touch R.”
Once the LED stops
flashing on the Right
earbud, you are
connected and ready
to go.