Need help?Do you have a question about the Roxcore Pins ANC and is the answer not in the manual?
Turn the headset on by removing earbuds; turn off by placing them in the case or holding the earbud.
Connect USB-C to the case and power source; LEDs indicate battery level.
Remove earbuds from case to auto-pair; connect via device Bluetooth settings.
Control playback, volume, track skipping, and activate voice assistant via earbud taps.
Toggle Active Noise Cancellation by tapping and holding an earbud for two seconds.
Answer/end calls with a single tap; reject calls by holding for two seconds.
Reset earbuds by holding them for 10 seconds until LED blinks red, then place in case.
Steps to resolve pairing issues, including checking proximity and interference.
How to re-pair earbuds if previous pairing fails, by forgetting the device.
Tips for maintaining a stable Bluetooth connection, focusing on distance and interference.
Factors affecting battery life and tips for conserving power, like returning earbuds to the case.
How earbuds automatically reconnect to the last paired device when removed from the case.
General| Type | Over-ear |
|---|---|
| Wireless | Yes |
| Bluetooth | Yes |
| Active Noise Cancellation | Yes |
| Driver Size | 40 mm |
| Frequency Response | 20 Hz - 20 kHz |
| Sensitivity | 105 dB |
| Bluetooth Version | 5.0 |
| Charging Time | 2 hours |
| Microphone | Yes |
| Impedance | 32 Ohm |
To Next Page