Connecting the hob to the mains power supply
a) The power supply should be connected in compliance with the
relevant standard, or a single-pole circuit breaker. The method of
connection is shown below.
b) For power cord with plug, it can be used directly.
1. If the cable is damaged or needs replacing, this should be done by an after-sales
technician using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be installed with a minimum gap of 3mm between the
contacts.
3. The installer must ensure that the correct electrical connection has been made
and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a properly qualified
person.
The bottom surface and the power cord of the hob are not accessible after
installation
120V~
L
Brown
Blue
N
Electrical shock hazard
Operation and maintenance
Do not cook on a broken or cracked cooktop. If the cooktop surface should break
or crack, switch the ap- pliance off immediately at the mains power supply (wall
switch) and contact a qualified technician.
Switch the cooktop off at the wall before cleaning or maintenance.
Failure to follow this advice may result in electrical shock or death.
Health hazard
This appliance complies with electromagnetic safety standards.
However, persons with cardiac pacemakers or other electrical implants (such as
insulin pumps) must consult with their doctor or implant manufacturer before
using this appliance to make sure that their implants will not be affected by the
electromagnetic field.
Failure to follow this advice may result in death.
To Next Page
Loading...