Royal Outdoor Products Cascade User Manual

Cascade Fence Installation Instructions
3/08
1) Dig postholes 72” on center. Holes
should be 9-12” in diameter and 30” in
ground. (Fig. 1)
2) Place post in hole and tap down so
that there is 2” of clearance from
ground. (Do not set posts
permanently in place at this time)
3) (Fig. 3) Insert the reinforcement rail
into the bottom rail. Insert rail locks
into rail lock holes. Install bottom rail
into posts.
4) With bottom rail installed, level bottom
rail by tapping on posts. Make sure to
maintain 2” ground clearance.
5) When posts and rails are leveled,
postholes may be packed and filled.
Crushed stone or concrete may be used.
If using concrete, let concrete set before
continuing installation. Keep concrete
4” – 6” below ground level.
6) Install top rail in same fashion as
bottom rail in operation #3. (Fig. 2)
Note that the picket holes are larger
on the rail bottom and face down!
7) Install pickets by inserting down
through the top rail and locking tabs into
the bottom rail.
8) Install picket caps and post caps
(4” flat shown) by pressing into
place. A dab of PVC glue may be
used to secure caps permanently in
place. (Fig. 2)
Picket Cap
7/8” x 3”
Picket
Top Rail
N
otched Tab
Bottom Rail
Post Cap
Post
Fig 2
Fig 1
Reinforcement
Rail
Fig 3
Royal Outdoor Products. PO Box 360. Milford, IN 46542
Phone 800-365-3625. Fax 574-658-3147

Royal Outdoor Products Cascade Specifications

General

Material	Steel
Color	Black
Lock Included	No
Height	72 inches
Width	48 inches

Summary

Cascade Fence Installation Guide

Digging Postholes

Dig postholes 72" on center, 9-12" diameter and 30" deep for fence posts.

Setting Fence Posts

Place posts in holes with 2" ground clearance and tap down, do not set permanently yet.

Installing Bottom Rail

Insert reinforcement rail, locks, and bottom rail into posts, ensuring proper fit.

Leveling Fence Rails

Level the bottom rail by tapping posts, maintaining 2" ground clearance.

Filling Postholes

Pack and fill postholes with stone or concrete after leveling, keeping fill below ground.

Installing Top Rail

Install top rail like the bottom rail, ensuring picket holes face downwards.

Inserting Pickets

Insert pickets through the top rail and lock their tabs into the bottom rail.

Attaching Fence Caps

Press picket and post caps into place, optionally securing with PVC glue.