Need help?Do you have a question about the Royal 680 and is the answer not in the manual?
General| Brand | Royal |
|---|---|
| Model | 680 |
| Type | Ceiling Fan |
| Wattage | 75W |
| Frequency | 50Hz |
| Motor Type | AC |
| Voltage | 220V |
| Color | White |
The fan requires an air intake with a diameter of 14 cm, preferably external.
For existing fireplaces, a compartment under the Inserto base is needed to house the fan.
Open the door and remove the grille and cast iron base (1).
Remove the ash box (2) and the counter box (3) by unscrewing screws (V).
Assemble the flange 5 on the fan (Fig. 5).
Insert the fan in the Inserto compartment and secure it with the screws.
Remove the plugs (6) located on the front under the cast iron base.
Screw the thermostat (8) onto the firebox structure and connect cables.
Install the sensor (12) in the air duct and connect it to the control unit.
Replace the counter box, fasten with screws, and replace gasket if damaged.
Check control unit power, fuse, and thermostat for proper operation.
Example of ducting; optimal airflow with specific lengths and insulation.
To Next Page