Royal WINNIPEG 6 User Manual

Winnipeg 6
Check list
Polycotton Flysheet
Inner Tents x 2
Poles
Pegs
Pole Sleeves
Drop in Groundsheet
Canopy
Repair kit
Instructions
Thank you for purchasing a Royal Winnipeg 6 tent. It is advised that you check and erect
your tent before use. It is strongly advised that you “Weather your tent” before use. This
involves erecting the tent (as per the instructions below) and then either leaving it up to get
wet or hosing it down with a hose pipe. This allows you to see if there are any problems.
Enclosed is a repair kit, in the kit is a small tube of seam seal, which can be used on the
inside of the tent seams (not to be used on the bedroom compartment material). If you tent
should have a missing part or any other issue please contact the dealer you purchased it
from.
On arrival at you camping area please make sure that the ground is free from any sharp
objects or other objects that may damage the tent.
Assemble spring-adjoined poles by inserting each pole-end into the end of the next pole.
Ensure that shaped pole ends are correctly aligned before joining them. They do not require
force. Lay them parallel on the ground.

Royal WINNIPEG 6 Specifications

General

Brand	Royal
Model	WINNIPEG 6
Category	Tent
Language	English

Summary

Tent Setup Guide

Ground Preparation and Pole Assembly

Prepare the camping ground and assemble spring-adjoined poles by joining ends correctly.

Flysheet Positioning and Initial Pegging

Open flysheet, close zips, slacken straps, and position tent before inserting roof poles.

Attaching Roof Poles and Uprights

Insert curved roof poles into sleeves and attach upright poles to roof poles and anchor straps.

Securing Tent Shape with Pegs

Lay connected arches on the ground, peg rear corners, lift tent, and peg opposite anchor straps.

Stabilizing Tent Structure

Peg remaining points, attach brow poles for stability, and secure with pockets and ties.

Installing Side and Annexe Poles

Insert thin black poles into side sleeves and fit yellow-banded poles for the annexe area.

Attaching Inner Tents and Groundsheet

Zip groundsheet to flysheet, position inner tents, and attach them using colour-coded fastenings.

Canopy and Door Pole Installation

Peg out canopy with red-marked poles, zip on canopy, and use steel poles for door access.