RS Biotech Galaxy S+ - Unpacking and Installation; Box Inspection and Unpacking Procedures

7
RS Biotech User Guide
2
2
U
U
N
N
P
P
A
A
C
C
K
K
I
I
N
N
G
G
&
&
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
2.1 Inspection of Boxes
After you have received your order from RS Biotech, inspect the boxes carefully for
any damage that may have occurred during shipping. Report any damage to the
carrier and to your local RS Biotech distributor immediately.
2.2 Unpacking
WARNING!
At least two people are required to safely lift your Galaxy S Plus.
Disassemble the wooden shipping crate and remove the protective packing. Save
the packing materials for possible future use, and be sure to save this User’s Guide
for instruction and reference.
To simplify lifting the incubator, leave it on the pallet. You must have at least one
person at either side to safely lift the unit. Supported by the base only, remove the
incubator by lifting it from the delivery pallet.
#NOTE:
Remove the transportation bracket from the front underside of the incubator at
the opposite side to the hinge side.
Locate and remove the parts stored in the Humidity Tray.
If any part of your order was damaged during shipping, is missing, or fails to operate,
please contact your RS Biotech distributor.
Using your RS Biotech packing list, verify that you have received the correct
materials, and that nothing is missing.
Table 1 on the following page outlines the accessory items that are supplied with
your new incubator: