5. he foot
on to the port side of the sail keeping the
6. w outhaul slug
slide in to the boom cut out first, followed by
7. ugh the
to the reefing slug slide as
8. Thread the Cunningham line through
the three eyelets in the luff of the
r
ainsail halyard if
udder
Slu
Roll the sail as tight as possible from t
eyelets on the luff and the slug slides on the
leech parallel and in line.
Feed the original, lower cle
the higher reefing slug slide second.
Re-attach the outhaul control line thro
eye attached
shown.
mainsail and re-fasten in the slot unde
the gooseneck.
Re-tension the m
9.
required.
R
ch the rudder assembly to the
transom:
condary rudder retaining split
ring to the top rudder pintle.
retaining clip
is adjusted and has engaged correctly
1. Atta
a. Fit the se
b. Ensure the primary rudder-
23
To Next Page
Loading...
