RS 1319A - Data Logging and Clearing; Disable Auto Power Off

4-3 To Trigger "One by One Datalogging" and Clear Stored Data
c Press "MEM" key each time, stores one set logged
reading in memory, LCD will show " MEM " and memory
location numbers (1 to 150).
d Press "READ" key to enter the reading memory data
mode. LCD will show " READ " and memory location
numbers.
e Press "S" or "T" key to scroll through the logged
readings.
f Press "READ" key again to exit READ mode.
g To Clear the Memory Data
a). Press "
" key to turn off the meter.
b). Press and hold down "MEN" key then press "
" key to
turn on the meter, LCD will show "ALL CLr" mark, press
T key select “
” or “ ”, then press “MEM” key
exit this mode. If you select yes the all memory will be
cleared.
4-4 How to Disable Auto Power off Function
The meter will enter to the sleep mode if no key pressed
occurs for 30 minutes.
c Press "
" key to turn off the meter.
d Press and hold down " H HOLD " key then press " "
key to turn on the meter, the “P” and “OFF” indication one
time, the auto power off function will be disabled.
The auto power off mark " P " on the memory display will
disappeared.
Auto power off mode is enabled each time you turn on
the meter and is automatically disabled in "MX/MN" mode.
6