2
1.1
1.2
Remove the two screws then remove the
mainsheet block, eyelet and plastic base.
Remove the shackle, spring and eyelet
from the block.
Add some sealant down the two existing holes left by the screws
removed in step 1.1.
1. How to convert your Aero to accept the new mainsheet ratchet base
Line up the holes in the new mainsheet ratchet
base adapter plate with the holes in the boat
and screw into place using the countersunk
screws provided.
1.3
Make sure the third hole in the base plate is
forward of the other two holes.
The screws must be tight
To Next Page
Loading...
