3
Compress the existing spring (as removed in step 1.1) using cable ties
then shackle the ratchet block onto the eyelet.
1.4
1.5
Using the mounting bracket as a guide, drill the third hole using a 3mm drill bit.
Add sealant and screw down.
Add the eyelet onto the ratchet base.
If you wish to use the new ratchet base, see step 1.5 - 1.7 for how to add it.
If you wish to use a swivel base, move on to section 2.4
1.6
Make sure the plastic spring washer goes
back on the right way up.
Once the shackle is tightened, cut the cable
ties.
The screws must be tight
To Next Page
Loading...
