2). Connect the tiller extension to the tiller by pushing the red joint into the housing and locking the bayonet clip
by rotating the outer collar. The flexible joint of the tiller extension will perform better if it is removed from the tiller
after use.
3). The daggerboard simply drops into the case. Secure the daggerboard in place using the shockcord and
hook. The daggerboard should be stiff enough in its housing to stop at the point it is raised, and initially may be
quite stiff to pull up and down. This ensures that there is no ‘slop’ or movement in the case helps give the Vareo
its characteristic and precise feel and control. Should you find the daggerboard to be over stiff, gentle abrasion of
the inside lip of the case and the daggerboard itself will improve movement.
To Next Page
Loading...
