Need help?Do you have a question about the RTA 435NBX-N700 and is the answer not in the manual?
Describes the required DC power source and its specifications for the gateway.
Details the jumper settings for RS232, RS485, and RS422 configurations.
Steps for when the gateway's main configuration page fails to load.
Explains how to navigate between different pages using the left-hand menu.
Provides a high-level overview of ASCII port statuses on the main page.
Specifies the PLC tag or file name for ASCII to PLC data transfer.
Configures message queue size and behavior when full.
Defines how NULL characters are handled during data conversion.
Specifies the PLC tag or file name for PLC to ASCII data transfer.
Sets the maximum characters the gateway sends to the ASCII device.
Defines how NULL characters are handled for data sent to ASCII devices.
Displays the connection status between the gateway and the PLC.
Allows navigation to specific port diagnostics and data direction selection.
Shows the last message successfully sent from the gateway to the PLC.
Displays the next ASCII message waiting to be sent to the PLC.
Shows real-time data being sent from the ASCII device to the gateway.
Enables sending a test message to the PLC for verification.
Counters for delimiter, length, timeout, and discards in ASCII events.
Counters for successful and failed handshake messages from the PLC.
Counters for successful and failed messages sent from ASCII to PLC.
Shows the last message successfully sent from the PLC to the ASCII device.
Enables sending a test message to the ASCII device from the gateway.
Counters for read requests and errors when reading ASCII messages from PLC.
Counters for successful and failed handshake messages from PLC to ASCII device.
Details possible values for PLC connection status on the main page.
Details possible values for ASCII device status on the main page.
Shows status of ASCII to CompactLogix communication for each port.
Shows status of CompactLogix to ASCII communication for each port.
Saves the gateway's current configuration to a PC file.
Loads a saved configuration file onto the gateway.
Displays the gateway's full catalog number for support.
Enables logging for diagnostic purposes, guided by support specialists.
Configures username, password, and hint for gateway access.
Details how configuration data is written to and read from the SD card.
Explains IP address modification precautions when using an SD card.
Defines various error codes encountered during gateway operation.
Details the byte breakdown for input and output assemblies in I/O messaging.
Explains diagnostic counters and statuses relevant to I/O messaging.
To Next Page
General