REW Depressing this switch will start the tape in the
rewind mode. The tape will move in high
speed rewind until the beginning leader is
detected. At this point the tape will stop.
FWD The forward switch will start the videotape
moving in fast forward. It will continue until
the tail leader is detected or another switch is
depressed.
MEMBRANE KEYBOARDS
The following descriptions are for the keys on the right-hand keypad located under the LCD Display.
This display shows defect and tape length information as well as various messages and diagnostics.
ERASE This Erase switch is used to initiate the erase
function on cassettes that are not erase
protected. To initiate the optional erase
function, the operator depresses the ERASE
key followed immediately by the AUTO
switch, followed again by the ERASE key. If
this sequence of 3 commands is made within 3
seconds, the machine will go into the ERASE
mode. Since the erase function is tied to the
auto function, the operator is insured that the
entire videotape will be erased.
RESET The reset key clears all of the defect data and
tape information from the memory of the
TapeChek 4100 machine. It also clears
information such as Tape # and Operator #
from the memory. The Date is retained until
the power is turned off.
CLEAR This key is used to clear incorrect data when
entering the Date, Operator # or Tape #. It
does not clear the memory in the machine of
other data, such as defect locations, etc.
DISPLAY The display key changes the information shown
on the LCD display. Pressing the display key
will sequence the operator through the various
displays available on the TapeChek 4100. (See
Page 11 - 14 in the Operator Manual )
9
To Next Page
Loading...