OPERATOR CONTROLS
TAPECHEK 4100 EVALUATOR/CLEANER
The following is a description of the push button controls and keys on the front panel of the
TapeChek 4100 Betacam unit.
TRANSPORT PANEL SWITCHES:
POWER This Power switch turns ON and OFF the main
power. When this switch is depressed, it lights
up and the main power is turned on to the
machine. If a video cassette is loaded into the
machine at the time the power switch is turned
off, the machine will automatically go through
a cassette eject cycle before the power is turned
off. This condition will be indicated to the
operator by a series of beeps at the time the
power switch is depressed.
EJECT: The Eject key initiates the eject sequence that
removes the cassette from the machine.
STOP: Depressing this switch will stop the tape from
moving in either the forward or rewind direc-
tions and Eject the tape if in the Erase mode.
AUTO: The Auto key initiates the automatic inspection
and cleaning of the videotape. In the auto mode
the tape is run forward to the end of the tape
and is then automatically rewound back to the
beginning. At the end of the auto cycle, the
videotape is ejected from the machine. At this
time a printed report can be obtained from the
optional printer system. If the auto switch (like
other switches) is depressed during the loading
cycle, the switch light will blink. After the
loading cycle is complete, the Auto and
Forward lights will light constantly, indicating
that the Auto mode has begun.
8
To Next Page
Loading...