Page 2 of 5
Power Selector Switch
Low Pressure Gauge
Cap
Cap
Cap
Red Field Service Coupler
Stored on Parking Fitting
Blue Field Service Coupler
Stored on Parking Fitting
Blue Hose
Keypad
Red Hose
Oil Charge Bottle
Oil Drain Bottle
Attention Light
High Pressure Gauge
Setup - RHS780
Refer to the illustration and attach accessories as follows:
1. Store the FSC to ACME Adapter in a secure place. This adapter is used to connect the Blue Field
Service Coupler to a tank with a 0.500 ACME fitting.
2. Install Red Field Service Coupler on end of Red Hose.
3. Connect other end of Red Hose to left port (when facing back of unit) on rear of RHS780. The port has a red
band.
4. Install Blue Field Service Coupler on end of Blue Hose.
5. Connect other end of Blue Hose to right port (when facing back of unit) on rear of RHS780. The port has a blue
band.
6. The Field Service Couplers should be connected to the parking fittings on the front of the RHS780 when not in
use to protect the seals and prevent debris from entering.
7. Install Oil Charge Bottle on top port on the side of the RHS780. Close the valve by turning knob clockwise.
8. Install Oil Drain Bottle on lower port on side of the RHS780. Close the valve by turning knob clockwise.
9. Make sure caps are screwed onto three ports on left side of RHS780.
To Next Page
Loading...
General