Why is the RTS DV 2066S Radio communication range so short?
If you're experiencing a short communication range or bad sensitivity with your RTS Radio, there are a couple of things to check: * First, make sure the antenna is correct and properly connected to the antenna port. * Also, verify that the channel is not set to Low power. Debris or damage to the antenna connector can also cause this issue.
What to do if there is no sound from RTS Radio speaker?
If no sound is coming from the speaker of your RTS Radio, it could be due to a muted squelch. Try decreasing the squelch level. Also, check if Tone or CTCSS/DCS squelch is active and turn it off if it is.
Why does my RTS DV 2066S have noise after programming?
If the whole band has noise after programming your RTS Radio, the squelch was likely opened during the programming process.
What to do if RTS DV 2066S Radio does not scan?
If your RTS Radio is not scanning, ensure you've added the desired channel to the scanlist during programming.
Why nothing appears on RTS Radio display?
If the power is on but nothing appears on the display of your RTS Radio, check the polarity of the power connection. Ensure the red lead is connected to the plus terminal and the black lead to the minus terminal of the DC power supply.
What to do if the RTS Radio fuse is blown?
If the fuse is blown in your RTS Radio, you should identify and resolve the underlying problem that caused the fuse to blow. After fixing the issue, replace the blown fuse with a new one.
General| Frequency Stability | ±2.5 ppm |
|---|---|
| Operating Temperature | -30°C to +60°C |
| Frequency Band | VHF: 136-174 MHz |
| Power Supply | 7.4 VDC |
| Channels | 128 |
| Frequency Range | 136-174 MHz |
| Output Power | 5W |
To Next Page
