Why RugDoctor Ultrasonic Jewelry Cleaner has no power?
Your RugDoctor Ultrasonic Jewelry Cleaner might not be receiving power because the power cord isn't properly plugged into the wall outlet. Ensure the power cord is securely connected. Also, make sure that the power button is turned on.
What to do if RugDoctor Ultrasonic Jewelry Cleaner has no or low spray?
If your RugDoctor Ultrasonic Jewelry Cleaner is not spraying or the spray is weak, try the following: First, ensure you are pressing and holding the cleaning solution trigger. Next, check if the clean water tank is empty or low; if so, fill it with water and solution. Also, make sure the clean water tank is correctly locked into position; you should hear a click when it's properly installed. Finally, the valve of the clean water tank might be clogged. Remove the valve from the bottom of the tank and clean it with warm soapy water.
Why RugDoctor Ultrasonic Jewelry Cleaner rotating brush doesn’t rotate?
If the rotating brush on your RugDoctor Ultrasonic Jewelry Cleaner isn't rotating, it might be because something is lodged in the brush roll. To resolve this, turn off the machine and unplug the power cord. Check for any obstructions preventing the brush roll from rotating. You can remove the brush roll by unlocking the cover with a coin or screwdriver on the bottom of the machine. Clean the brush roll and ensure it spins freely. Replace the brush roll and secure it by locking the cover. Then, plug the machine back in and turn it on to continue cleaning.
General| Brand | RugDoctor |
|---|---|
| Model | FlexClean FCM-1 |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page
