Ruger 77/50 - Reassembling Barrel and Stock; Installing Barrel;Receiver into Stock; Reinstalling Trigger Guard

5. To replace the barrel/receiver assembly into the stock: (Caution: Be certain
that the pivot pins are not protruding from either side of the receiver.)
a. Carefully install the barrel/receiver assembly into the stock, making sure
the barrel/receiver assembly is in the most rearward position.
(See Figure 29)
b. Install the trigger guard and screws (shorter screw in front).
(See Figure 30)
29
C
A
B
SHORT SCREW
IN FRONT
30
REINSTALL TRIGGER GUARD
INSERT BARRELLED ACTION INTO STOCK
32