S2600E/P CLI Reference Guide Chapter 2 Switch Management Configuration
Commands
2.1.7 ip http
authenticatio
n
When using the Http Server, it needs to perform the logon authentication to
enter the Web page. Use this command to set the mode of Web logon
authentication.
ip http authentication {enable | local }
Keyword Description
enable
Use the password set by the enable
password or enable secret, the password
must be of the level15.
Parameter
description
local
Use the username and password set by the
local username command. The user must
bind to the privilege of level15.
Default
enable
Command
mode
Global configuration mode.
Usage
guidelines
This command is used to set the mode of Web logon
authentication. Use the no ip http authentication
command to restore it to the default setting.
Examples
The example below sets the mode of Web logon
authentication as local:
Ruijie(Config)# ip http authentication local
Command Description
Related
commands
enable service
Enable or disable the specified
service.
2.1.8 ip http port
To set the port of the HTTP service ,use this command in the global
configuration mode:
ip http port number
To Next Page
Loading...