S2600E/P CLI Reference Guide Chapter 2 Switch Management Configuration
Commands
Command Description
Related
commands
telnet
log in a Telnet server
2.1.11 lock
To set a temporary password at the terminal, execute the EXEC mode
command lock.
lock
Parameter
description
N/A.
Command
mode
Privileged mode.
Usage
guidelines
You can lock the terminal interface but maintain the
continuity of session, to prevent it from being accessed by
setting the temporary password.The terminal interface can
be locked by the steps below:
1. Enter the lock command, and the system will prompt
you to enter the password:
2. Enter the password, which may be any string.The
system will prompt you to confirm the entered
password, and then clear the screen as well as show
the "Locked" information.
3. To enter into the terminal, enter the set temporary
password.
To use the terminal locked function at the terminal,
execute the lockable command in the line configuration
mode, and enable the characteristic to support the terminal
lock in corresponding line.
Examples
The example below locks a terminal interface:
Ruijie(config-line)# lockable
Ruijie(config-line)# end
Ruijie# lock
Password: <password>
Again: <password>
Locked
Password: <password>
Ruijie#
To Next Page
Loading...