S2600E/P CLI Reference Guide Chapter 2 Switch Management Configuration
Commands
Command Description
Related
commands
lockable
Set to support the terminal lock
function in the line.
2.1.12 lockable
To support the use of the lock command at the terminal, execute the lockable
command in the line configuration mode. The terminal doesn’t support the lock
command, by default.Use the no command to cancel the setting.
lockable
no lockable
Parameter
description
N/A.
Command
mode
Line configuration mode.
Usage
guidelines
This command is used to support the terminal lock function
in corresponding line. To lock the terminal, execute the
lock command in the EXEC mode.
Examples
The example below enables the terminal lock function at
the console port and locks the console:
Ruijie(config)# line console 0
Ruijie(config-line)# lockable
Ruijie(config-line)# end
Ruijie# lock
Password: <password>
Again: <password>
Locked
Password: <password>
Ruijie#
Command Description
Related
commands
lock
Lock the terminal.
To Next Page
Loading...