06 07
CLEANING
Sanitize Before First Use
Disassemble all parts.
Clean with warm soapy water.
DO NOT wash tubing or tubing connector.
Rinse well.
Using a large pot, place washable parts in boiling water
for no longer than 10 minutes. Make sure all parts stay
afloat while boiling. Extended direct contact with bottom
of pot may damage parts.
DO NOT cover the pot.
Allow the parts to air dry before use.
After each use
Remove Tubing and set aside.
Separate all parts.
Rinse them with cold water immediately after use.
Wash in warm soapy water.
Rinse and air-dry.
Wet components may affect performance. Please ensure that all
parts are completely dry before use
Covered pots or steam sanitizer systems can damage parts.
Do not use cleaning brush inside valves as this may damage the
valve and shorten its life span.
Tubing
Wipe outside of tubing with a clean, damp cloth.
Avoid moisture inside tubing.
If liquid is found inside tubing, rinse tubing with
clean, hot water and hang dry.
AIR DRY COMPLETELY BEFORE USE.
DO NOT insert any object into the tubing.
The Rumble Tuff® Go Cups are closed system which keep milk
from entering tubing. If milk is entering tubing, contact
customer service.
With thumb and forefinger,
gently seal any openings
on the tip of the one-way
valve and shape into
straight line.
Properly functioning valves are critical to the performance
of pump. Replace if damage detected.
(continued)CLEANING
One-Way Valve
Rub gently between fingers
in warm soapy water.
Rinse thoroughly.
To Next Page
Loading...
