Web: www.pacificwater.com.au TEL: 07 3376 9009 FAX: +61 7 3374 4716
Page 10 of 12
Once the softener is programmed you can now start passing water through the
unit
• Fill the Cabinet brine tank with water approx. 25mm above the salt
platform
• Add at least two bags of salt to the platform
• Put the softener into Regeneration – screen will display -00- this is the
valve moving into the backwash cycle, once this has stopped the
backwash symbol will be displayed and the minutes will start
counting down.
• Slowly open the inlet water connection a ¼ turn to allow a small flow of
water into the softener to releasing air out of the cylinder
• Once all the air has been removed from the cylinder you can now open
the inlet valve fully to clean the resin bed
• When the water is running clear press the regen button again to skip to
the next cycle
• The valve will now be in Brine draw cycle, press the regen button again
to skip to brine refill
• Allow the valve to top up the brine tank to the required level for a salt
solution
• Once refill has completed leave the valve to complete the regeneration
process and rinse the resin bed
To Next Page
Loading...
