To Next PageTo Next Page
Need help?Do you have a question about the Runxin Runlucky RL-Q01 and is the answer not in the manual?
General| Model | RL-Q01 |
|---|---|
| Brand | Runxin Runlucky |
| Category | Water Dispenser |
| Voltage | 220V |
| Capacity | 5L |
| Material | Plastic |
| Color | White |
Features a disk filter designed for inverted installation.
Incorporates an automatic backwash system for efficient cleaning.
Automatically cuts off water supply when leakage is detected.
Allows the inlet and outlet ports to be rotated a full 360 degrees.
Includes a check valve in the outlet to prevent backflow.
Features a user-friendly design with an integrated LED indicator lamp.
Provides a connector for an external RUNXIN leakage sensor.
Ensure installation conditions match the product's operating environment.
Install after the water meter but before other equipment.
Avoid areas with water accumulation or direct exposure to rain/sunlight.
Install a regulator valve if pipeline pressure changes suddenly.
The drain must be positioned lower than the product itself.
Ensure the distance to the power socket is less than the power line length.
Avoid drilling into subsurface pipes when installing screws.
Reach out to after-sales service or professionals for any questions.
Shows residual water, current flow rate, and current time.
Interface locks automatically after one minute of no operation.
Includes manual backwash and manual shut-off for maintenance.
Allows configuration of time, water capacity, closing time, peak flow, and interval days.
Troubleshooting steps for motor, wiring, and board related errors.
Addresses causes and solutions for zero current flow rate.
Solutions for decreased outlet flow due to filter or net blockages.
Diagnoses and fixes for backwash failures, including low pressure or stuck seats.
Resolves issues related to small peak flow rate or short closing times.
