12
※Please strictly use the salt of more than 99% purity only. Any salt with additive or large particles is
forbidden to add.
※Please use this product under the water temperature between 5～45℃,water pressure 0.15～
0.6MPa. Failure to use this product under such conditions voids the warranty.
※Sodium used in the water softening process should be considered as part of your overall dietary salt
intake. Contact doctor if you are on a low sodium diet.
※Without being used for a long time or the pressure of the inlet water is instable, please close the
inlet port and turn off the power. Before using again, please firstly conduct a regeneration cycle through
manual operation so as to ensure the quality of soften water.
※During the service of product, prevent water hammer happened. Do not make these operations,
such as quickly and fully opening valve, or quickly and fully closing valve or shut off water pump, etc.
※ If the water demand is increasing (Compared to usual demand) or the hardness of raw water is
rising, please reduce the regeneration cycle and increase the regeneration times, ensuring the soften
water yield.
※ When use the softener for the first time or the device is idle for long period, it is normal that the
outlet water is yellow. Please put into use after 2~3 minutes’ rinsing.
※ Sometimes the brine in the brine tank will forms salt bridge. That is, there is a space under the
brine which prevents the salt from being dissolved and hinders the resin regeneration. It is suggested to
check regularly. If there is salt bridge, please mash it.
※During regeneration period, there is no softened water for using. But if it still need water for using,
it is not suggested to bypass big quantity of hard water, it may affect the regeneration efficiency.
※If the display board display 12:12 and flashing, it means power off (more than 3 days) to remind to
reset the time of day. If power off within a short time, the system has memory function, do not need to
To Next Page
Loading...
Need help?
General
