Need help?Do you have a question about the Rupprecht & Patashnick PARTISOL-PLUS 2025 and is the answer not in the manual?
General| Brand | Rupprecht & Patashnick |
|---|---|
| Model | PARTISOL-PLUS 2025 |
| Category | Measuring Instruments |
| Language | English |
Provides step-by-step instructions for setting up the unit for use as a Federal Reference Method sampler.
Details the procedure for weighing filters (tare weight) before sampling.
Details how to enter and use the Edit Mode to change system parameters.
Defines the different operating modes of the Partisol-Plus Sampler.
Details procedures to verify sampler performance characteristics prior to sampling.
Step-by-step instructions for programming the sampler for a sampling run.
Explains how to verify sampling run status and retrieve sampling run data.
Describes operational status codes displayed by the Partisol-Plus Sampler.
Details the records stored for each collection filter, including time, status, and averages.
Provides access to analog input/output, RS232, RS485, and Contact Closure capabilities.
Outlines the steps to set up the sampler for direct communication with a PC using a cable.
Explains how to download filter, interval, and input data from the sampler.
Explains the two levels of password protection (Low and High) and how to enable/disable them.
Details how to verify sampler performance characteristics prior to sampling.
Instructions for conducting an external leak check on the sampler.
Steps to verify the sampler's flow rate using standards or audit adapters.
Explains how to access the Service Mode via the Master Menu for diagnostics and calibration.
To Next Page