Ruris RXR1000 - User Manual

Questions and Answers

J
Joel McmillanAug 4, 2025
What to do if my Ruris RXR1000 Lawn Mower stops with the LED indicator flashing RED?
- T
  Terry DuffyAug 4, 2025
  If your Ruris Lawn Mower stops with the LED indicator flashing red, it could be due to several reasons: * The slope is larger than 30°: Encircle the steep slope area with boundary wire, keeping in mind that the maximum distance from the robot mower to its nearest boundary wire should be 15 m. * The robot mower cannot detect the signal from the boundary wire: Check the wire clamps on the docking station and splice any defects or cut-offs using the wire joints provided. Remember, a constant green light on the LED indicator means the boundary signal is ready. * The tilt sensor is activated, or the front wheels are trapped: Fix any holes in your lawn and ensure the wheel axles can rotate and slide freely. Always turn off the power first.
L
Linda SaundersAug 9, 2025
Why does my Ruris RXR1000 Lawn Mower run outside the boundary wire?
- A
  alexander71Aug 9, 2025
  If your Ruris Lawn Mower runs outside the boundary wire and stops close to it, it could be due to: * Wheels covered with mud: Clean the wheels of the robot mower and repair or clean your lawn. * Boundary wire too close to the edge: Move the boundary wire inwards for security reasons. * Detection function not working properly: Clean the wheels of the robot mower and repair or clean your lawn. Move the boundary wire inwards for security reasons.
A
Andrea ChambersAug 14, 2025
How to start Ruris Lawn Mower if it doesn't start?
- J
  Jamie GonzalezAug 14, 2025
  If your Ruris Lawn Mower doesn't start, ensure the security key is inserted for manual start in the docking station. Let the robot charge until the LED indicator displays a constant green light. Also, make sure the "IN" arrow on the docking station points towards your working area, and the wire end under the docking station is connected to the RED clamp.
R
Robert QuinnAug 19, 2025
How to fix big noise and vibration in Ruris RXR1000 Lawn Mower?
- N
  Natalie MillsAug 19, 2025
  If your Ruris Lawn Mower is making big noise and vibrating, reverse or replace the blades, ensuring you do all of them at the same time. If the blade disc is damaged, replace it. Also, make sure to fasten the nuts firmly.
R
Richard DoughertyAug 25, 2025
What to do if Ruris Lawn Mower doesn't follow boundary wire?
- H
  Hailey Williamson DDSAug 25, 2025
  If your Ruris Lawn Mower's initial drive along the boundary wire doesn't follow its track, it might be due to interference signals or a neighboring boundary wire being too close. Encircle the area of interference with your boundary wire and adjust the boundary wire so that the robot mower may detect the signal normally. Ensure your neighbor's boundary wire is at least 10 m away from yours.
M
Melissa JacksonAug 29, 2025
What to do if Ruris Lawn Mower stops and LED doesn't light?
- L
  Lisa TranAug 29, 2025
  If your Ruris Lawn Mower stops and the LED indicator does not light, take the robot back to the docking station and let it charge.